Crosley Washer Error Code E67

E67 means the microprocessor on your Crosley washer is receiving an incorrect input voltage. This fault is tied to the tub NTC thermistor circuit, where the voltage signal being read by the control board falls outside the expected range. The first step in diagnosing this code is to check the resistance of the tub NTC thermistor using Test 15.

It is not recommended to continue running the washer while E67 is active. The error indicates the control board cannot trust the temperature data it is receiving, which means the machine may not regulate wash conditions correctly. Running a cycle under these conditions could lead to improper washing performance or additional component stress.

A reset may temporarily clear the E67 code, but if the underlying fault in the NTC thermistor circuit or wiring has not been corrected, the code will return once the machine runs another cycle. Clearing the code without fixing the root cause is not a lasting solution. Proper diagnosis using Test 15 is necessary to resolve the fault permanently.

Some causes of E67 are DIY-friendly, such as reseating loose connectors or inspecting the wiring harness for visible damage. Testing the tub NTC thermistor requires a multimeter to measure resistance and compare it against the expected value. Replacing the thermistor is a moderately straightforward repair, but if the control board is the root cause, that repair is more complex and may warrant professional service.

Repair costs depend on the root cause. A replacement NTC thermistor is generally an inexpensive part, with total repair costs including labor typically ranging from around $75 to $200. If the control board needs replacement, parts and labor combined can range from $200 to $450 or more depending on parts availability and service rates in your area.