Crosley Washer Error Code EB3

EB3 means the washer's control board has detected that the incoming AC line voltage is below 90 VAC. The machine requires adequate voltage to operate safely and will display this code rather than continue running under low-voltage conditions. The fault may originate from the home's electrical supply or, less commonly, from the console control board itself misreading the voltage.

No, you should not continue running the washer while EB3 is active. Operating motors and electronics under low voltage conditions can cause overheating, premature component failure, and potential electrical hazards. Resolve the voltage issue or repair the control board before resuming use.

A reset may temporarily clear the code, but EB3 will return if the underlying cause is not addressed. If the supply voltage remains below 90 VAC or the control board continues to misread the voltage, the code will reappear as soon as the washer attempts to operate. A lasting fix requires correcting the electrical supply issue or replacing the faulty control board.

The first step is checking the outlet voltage with a voltmeter, which a confident DIYer can perform. If the outlet voltage is low, the fix involves household electrical work that may require a licensed electrician. If the outlet voltage is fine and the error persists, replacing the console control board is the next step, which is a moderate-difficulty repair involving disconnecting wiring harnesses and mounting hardware.

If the problem is a faulty outlet, repair costs typically range from $75 to $200 depending on the extent of the electrical work needed. If the console control board requires replacement, parts and labor combined generally range from $150 to $350. If the issue is a utility supply problem, costs will vary based on what your electrical provider or a licensed electrician determines is needed.