Crosley Washer Error Code F8

The F8 code on a Crosley washer indicates a water level sensor fault. The washer's control board is not receiving a valid signal from the sensor that monitors water levels inside the drum. Because the machine cannot accurately control filling or draining without this input, it stops the cycle and displays F8 to alert you to the problem.

A reset may temporarily clear the F8 code, but if the underlying fault in the water level sensor or its wiring has not been corrected, the error will return once the machine attempts to run a cycle. A reset is useful for confirming whether the fault is intermittent, but it is not a fix on its own. The sensor circuit must be diagnosed and repaired to resolve the error permanently.

If only a wire connection needs to be reseated or cleaned, the repair may cost very little, primarily your time. Replacing the water level sensor itself generally involves a parts cost in the range of $15 to $60 depending on the specific sensor required. If you hire a technician, expect total repair costs in the range of $100 to $200 when factoring in labor, though costs vary by region and service provider.

In many cases, yes. Start by unplugging the washer and inspecting the wire and terminal connections at the water level sensor for any looseness, corrosion, or damage. Also check the small pressure hose connected to the sensor for kinks or blockages. If connections and hoses are in good condition, the sensor itself likely needs replacement, which is a manageable repair for someone comfortable working with appliance components.

It is not advisable to continue using the washer with an active F8 fault. The water level sensor controls when the machine fills and drains, and operating without a reliable sensor signal could result in overfilling, incomplete draining, or flooding. The machine typically halts the cycle for this reason, and the fault should be diagnosed before resuming normal use.