Crosley Washer Error Code nd

The nd code stands for No Drain. It means the washer attempted to pump water out of the tub during a cycle but could not confirm the tub was empty within the allotted time. The machine stops the cycle at this point to prevent spinning with standing water. The most common causes are a clogged pump filter, a blocked drain hose, or a faulty drain pump.

No, you should not continue running the washer with the nd code present. The machine has already stopped the cycle because it cannot drain, and forcing it to proceed could result in water remaining in the drum during the spin cycle. This can cause excessive vibration, potential leaks, or further mechanical stress. Address the drain issue before running another load.

The cost depends on what component is at fault. Cleaning a clogged pump filter or straightening a drain hose costs nothing beyond your time. If the drain pump needs replacement, parts alone typically range from $30 to $80, with professional labor adding $100 to $200 on top of that depending on your area. A faulty pressure switch is generally less expensive to replace than a pump.

Start by cleaning the pump filter or coin trap, which is the most frequent cause of this code. Next, check the drain hose for kinks or obstructions and verify the standpipe is not clogged. If those steps do not resolve the issue, the drain pump itself may need to be tested and potentially replaced. If the pump checks out electrically, the water level pressure switch should be inspected as well.

Resetting the washer may clear the code temporarily, but it will return if the underlying drain problem is not corrected. The control board triggers the nd code based on actual system performance, so the fault will reappear as soon as the machine attempts to drain again under the same conditions. Focus on diagnosing the cause rather than relying on a reset to resolve it.