Electrolux Cooktop Error Code E16

E16 indicates that the right rear zone control key sensor has been detected as defective. The cooktop's control system monitors the touch sensor signals for each cooking zone, and E16 is triggered when the right rear zone sensor signal is outside expected parameters or communication between the zone control board and the main power touch control is lost. The affected zone may be disabled until the fault is corrected.

The right rear cooking zone should be considered unreliable while E16 is active, as the control system has flagged its sensor as defective. Avoid relying on that zone until the fault is resolved. If the cooktop allows other zones to operate normally and does not display additional error codes, those zones may still be used with caution, but repairing the fault promptly is recommended.

Repair costs vary depending on which component has failed. If only the cable or a connector needs attention, costs may be limited to a service call fee, typically in the range of $75 to $150. Replacing the center/right rear cook zone control touch panel assembly adds parts cost on top of labor, with total repairs often ranging from $150 to $350 or more depending on part pricing and your location. Replacing the main power touch control board, if needed, generally represents the higher end of the cost range.

Some steps are accessible to a confident DIYer. You can start by power cycling the cooktop and cleaning the touch control surface to rule out moisture or temporary faults. Checking that the cable connectors between the zone control and the main board are firmly seated is also a reasonable first step. However, replacing the touch control sub-assembly or main board involves working inside the appliance and should be handled by a qualified technician if you are not comfortable with appliance repair.

A power reset, performed by switching off the circuit breaker for one to two minutes and restoring power, may temporarily clear the error if it was caused by a transient signal issue or moisture. However, if the underlying cause is a defective sensor, damaged cable, or failed touch control board, the E16 error will return. A reset alone is not a repair.