Electrolux Washer Error Code 57

Error code 57 on an Electrolux washer means the inverter, which is the electronic board that controls the drive motor, has detected a high current condition. The washer shuts down to protect the motor and inverter circuitry from damage caused by excessive electrical current. The fault can stem from an overloaded drum, a problem with the motor windings, a damaged wiring harness, or a failing inverter board itself.

A reset may temporarily clear the code if the fault was caused by a one-time overload situation. However, if there is an underlying problem with the motor windings, inverter board, or wiring harness, the error code 57 will return once the machine attempts to run again. It is important to diagnose and correct the root cause rather than relying on repeated resets.

Repair costs depend on the faulty component. If the issue is simply an overloaded drum, there is no parts cost. A replacement drive motor typically ranges from $150 to $350 in parts, while an inverter board can range from $100 to $300 depending on the model. Adding professional labor costs, total repair bills can range from $200 to $600 or more depending on the diagnosis.

Start by checking whether the washer was overloaded and reduce the load size before attempting a restart. If the error returns, the motor and its winding resistance need to be tested, following diagnostic test procedure (8). If the motor windings show abnormal resistance readings or shorts, the motor will need to be replaced. If the motor checks out, the inverter board is likely the faulty component and should be inspected and replaced.

No, you should not continue using the washer while error code 57 is active. The fault indicates an overcurrent condition in the motor control system, and running the machine in this state risks causing permanent damage to the inverter board or the drive motor. Keep the washer powered off until the cause has been diagnosed and corrected.