mypros+
Model reference

Electrolux A07020001B

Washer

1 document53 error codes5 service modes

Available documentation

Tech Sheet

  • Washer Tech Data Sheet20 pg
    Covers this model
MyPros+ Max

Diagnose your Electrolux A07020001B.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (53)

CodeMeaning
11Fill time too long.13Water leak in tub or in pressure sensor.21Water not pumping out fast enough.23Drain triac error.24Drain triac error sensing.31Electronic pressure switch error.32Pressure sensor calibration problem.35Pressure sensor indicates water overfill.38Air trap clogged.41Control board thinks the door switch is open.42Door lock device failure.43Door lock triac failure.44Door closed sensing failure.45Line door sensing failure.55Motor under speed (not available on 300 series).57High current on inverter (motor control).58High current on motor phase.59No spin signal for 3 seconds.5AHigh temperature on control due to overload (motor control).5BMotor control under voltage.5CHigh voltage experienced by motor control (MC).5DCommunication problem with motor control (message).5ECommunication problem from motor control (communication failure).5FMC is continuously resetting.62Wash temperature too high.66Heater relay problem (on select models).68Current leakage to ground on heater or wiring (on select models).69Heater open (on select models).6AHeater relay sensing problem (on select models).71Drum water NTC failure (tub heater) (on select models).
View all 53 error codes
74Wash temperature does not increase.83Wrong selector reading.84Recirculation pump triac sensing failure which stops the cycle (on select…85Recirculation pump triac alarm which stops the cycle (on select models).86Incorrect UI selection table.87User interface microcontroller fault.91UI_MB communications error.92Communication error UI to main board (incompatible configuration).93Console or Main Board control problem (incompatible machine configuration).94Main Board control problem (incompatible cycle configuration).97Console or Main Board control problem (incompatible cycle configuration).98Incompatible motor control/Main Board.9CUser Interface configuration problem.9ETouch sensor on user interface not responding.F2Too much soap or wrong type.F5Load unbalanced.F6Control reset.F9Hot valve warningH1/B1Frequency of power out of limits.H2/B2Supply voltage too high (incoming voltage).H3/B3Supply voltage too high (incoming voltage).HE/BEControl relay fault.HF/BFControl relay sense fault.

Service modes (5)

  • demo_mode_push_button["1
  • demo_mode_rotary["1
  • diagnostic["1
  • factory_default_reset["1
  • recall_last_error_code["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Electrolux washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax