Frigidaire Dryer Error Code E35

E35 on a Frigidaire combo washer-dryer means the pressure sensor has detected a water overfill condition inside the wash tub. The unit stops the cycle to prevent flooding or damage. The error involves the water level system, including the water inlet valve, the pressure sensor, and the hose connecting the sensor to the tub. Diagnostics should follow test (5), which checks the actual water level, continuous fill behavior, and pressure sensor operation.

No, you should not continue running the appliance while E35 is active. The code indicates a potential overfill condition, meaning excess water may already be present in the tub or could enter during the next cycle. Running the unit risks water leaking onto the floor or into internal components, which can cause further damage or create a slip hazard.

A reset may temporarily clear the E35 code, but it will return if the underlying cause is not addressed. If the water inlet valve is stuck open or the pressure sensor is faulty, the overfill condition will recur as soon as the machine attempts to fill again. It is important to complete the proper diagnostic checks before relying on a reset as a solution.

Some causes of E35 are DIY-friendly. You can inspect the pressure sensor hose for kinks, clogs, or disconnections without special tools, and clearing a blockage or reseating the hose may resolve the error. However, replacing a failed water inlet valve or pressure sensor requires comfort with appliance disassembly and basic electrical testing, so less experienced users may prefer to call a technician.

Repair costs depend on which component has failed. A replacement pressure sensor typically runs in the range of $20 to $60 for the part alone, while a water inlet valve generally costs between $30 and $80. If a technician is needed, add labor costs of roughly $75 to $150 depending on your location and the complexity of the repair.