Frigidaire Dryer Error Code E43

E43 indicates the control board attempted to lock the lid but did not receive confirmation that the lock engaged successfully. The appliance stops the cycle and displays this code as a safety precaution. The fault can be caused by a bad lid lock assembly, wiring issues, or a defective control board. The recommended starting point for diagnosis is test (6) in the service diagnostic procedure.

A reset may temporarily clear the code, but if the underlying fault is still present the error will return as soon as the appliance tries to lock the lid again. Resetting is not a fix and should only be used to confirm whether the fault is intermittent. Proper diagnosis following test (6) is required to resolve the issue permanently.

Repair costs depend on which component has failed. A lid lock assembly replacement typically falls in the range of $40 to $120 for the part, while a control board can range from $100 to $300 or more depending on availability. Adding a technician's labor, total repair costs generally range from $100 to $450. Diagnosing the fault with test (6) first ensures you replace only the component that has actually failed.

Some causes of E43, such as a loose wiring connector or a physical obstruction preventing the lid from closing, can be addressed by a knowledgeable DIYer. However, replacing the lid lock assembly or control board requires basic electrical testing skills and comfort working inside the appliance. If you are not familiar with continuity testing or reading wiring diagrams, having a technician perform the test (6) diagnostic sequence is the safer choice.

No. The E43 code is a safety-related fault. The lid lock is designed to prevent access to moving parts during a cycle, and the appliance intentionally stops operation when the lock cannot be confirmed. Running the machine with a bypassed or non-functional lid lock creates a safety hazard and should be avoided until the fault is repaired.