Frigidaire Dryer Error Code E44

E44 indicates a lid closed sensing failure in the washer-dryer system. The control board is not receiving a valid signal confirming the lid is shut, so the unit stops operation as a safety measure. The fault points to the lid switch, its wiring, or the lid strike mechanism. Diagnostic test (6) is the starting point for isolating the specific failure.

The unit is designed to halt operation when E44 is active, which is a built-in safety response to an unconfirmed lid position. Continuing to use the appliance while bypassing this error is not recommended, as the lid sensing circuit exists to prevent operation with an open lid. The fault should be diagnosed and repaired before returning the unit to regular service.

A power reset may temporarily clear the E44 code from the display, but the error will return if the underlying cause is not repaired. The lid switch or sensing circuit must be functioning correctly for the fault to stay resolved. Resetting alone is not a fix and should only be used as part of the diagnostic process to confirm whether the issue is intermittent or persistent.

A knowledgeable DIYer can address this error by following the test (6) diagnostic procedure, which involves inspecting and testing the lid switch and its wiring harness with a multimeter. Replacing a lid switch or repairing a wiring connector are straightforward repairs for someone comfortable working with appliance electrical components. However, if the control board is identified as the cause, that repair is more complex and may warrant a professional technician.

If the lid switch is the cause, replacement parts typically range from around $15 to $50 depending on the specific component. If a technician is needed for diagnosis and repair, total service costs including labor can range from $100 to $250 or more. A failed control board is the most expensive scenario, with parts and labor potentially ranging from $200 to $400 or higher.