Frigidaire Dryer Error Code E58

E58 means the dryer's control system has detected high current on a motor phase, indicating the drive motor is drawing more electricity than the normal operating range allows. This triggers a protective shutdown to prevent motor or board damage. The first diagnostic step is Test 8, which walks through motor circuit inspection procedures.

No, you should not continue operating the dryer while E58 is active. The code indicates a motor overcurrent condition, and running the appliance in this state risks damaging the drive motor, wiring, or control board further. Discontinue use until the root cause is identified and corrected.

A power reset may temporarily clear the E58 code, but the error will return if the underlying cause is not repaired. If the motor is mechanically overloaded or has a winding fault, the condition will persist and the dryer will shut down again. A reset is only useful as a first step to confirm whether the fault is intermittent or consistent, not as a permanent fix.

Some causes of E58 are DIY-friendly, such as removing a drum obstruction, clearing a clogged blower wheel, or reseating loose wiring connections. However, testing motor winding resistance and diagnosing control board faults requires a multimeter and comfort working around electrical components. If the motor or control board needs replacement, a qualified technician is recommended.

Repair costs vary widely depending on the cause. Clearing a mechanical obstruction or fixing a wiring connection may cost little to nothing beyond a service call fee, typically in the range of $75 to $150. Replacing a drive motor can run $150 to $400 in parts and labor, while a motor control or inverter board replacement may range from $200 to $500 or more depending on the specific board.