Frigidaire Dryer Error Code EAE

The EAE code means the dryer's control board has detected a line safe relay sensing failure. The control system monitors the relay to confirm it opens and closes correctly during operation, and EAE is triggered when that confirmation signal is missing or unexpected. The dryer will stop running until this fault is resolved. Diagnosis should begin with Test 11 as specified for this model.

No, you should not continue using the dryer while the EAE fault is active. The line safe relay is a safety-critical component, and a sensing failure means the control board cannot confirm that the relay is functioning correctly. Running the appliance in this condition could pose an electrical safety risk. Power off the dryer and have it inspected before operating it again.

A power reset by unplugging the dryer for a few minutes may temporarily clear the EAE code, but if the underlying hardware fault remains, the error will return once the dryer attempts to operate. The EAE code indicates a real circuit or component problem that a reset alone cannot fix. A proper diagnosis following Test 11 is needed to identify and correct the root cause before the dryer will operate reliably again.

Some causes of the EAE error, such as a loose wiring connector, can be addressed by a confident DIYer with basic electrical knowledge. However, the fault involves line-voltage components and safety relay circuitry, so caution is essential and the dryer must be fully unplugged before any inspection. If the relay or control board needs replacement, those repairs are more involved and may be better suited to a qualified technician. Always follow Test 11 to systematically isolate the failed component before replacing parts.

Repair costs vary depending on which component has failed. A wiring or connector fix may cost very little in parts, with labor being the primary expense. Relay replacement parts typically range from around $20 to $60, while a main control board can range from $100 to $250 or more depending on the specific model. Professional labor charges will add to these figures, so a full repair could range broadly from $75 to over $350 depending on the diagnosis.