GE Washer Error Code 319

Error code 319 on a GE washer indicates a Compressor Motor Inverter Fault. The compressor motor inverter board has detected a fault condition and reported it to the main control. This could be caused by out-of-range line voltage at the board, a wiring or connector issue, or a failure of the inverter board itself. The first diagnostic step is checking the AC voltage at connector CN8, pin 4 to pin 1, for a reading between 102 and 132 VAC.

You should not continue using the washer while code 319 is active. The compressor motor inverter fault means a critical component is not operating correctly, and running the machine could cause further damage to the inverter board or associated components. Power the unit off and perform diagnostics before attempting to run a wash cycle.

A basic power reset may temporarily clear the code, but it will almost certainly return if the underlying cause has not been addressed. The fault is tied to a hardware condition, specifically an inverter board fault or improper line voltage, that does not resolve on its own. A proper repair requires diagnosing and correcting the root cause, not just clearing the error.

Some causes of code 319 are accessible to a knowledgeable DIYer, such as inspecting connector CN8 for loose or corroded pins and verifying that the wall outlet is supplying proper voltage. However, measuring live AC voltage inside the washer and replacing the inverter board both require comfort with electrical work and appropriate safety precautions. If you are not experienced with appliance electrical diagnostics, it is safest to contact a qualified technician.

Repair costs depend on the root cause. If the issue is a loose connector or a wiring problem, the repair could be relatively inexpensive, primarily covering a service call fee in the range of 75 to 150 dollars. If the compressor motor inverter board needs replacement, parts and labor combined could range from 200 to 500 dollars or more depending on your location and the specific board required.