GE Washer Error Code 335

Error code 335 means the compressor motor inverter board has reported an internal fault. The inverter board controls the compressor motor by converting AC power into variable drive signals. This error causes the washer to stop operating until the underlying cause is identified and corrected. Diagnostics begin with checking the AC voltage supply at connector CN8 on the inverter board.

No, you should not attempt to run the washer while error code 335 is active. The inverter board is reporting a fault condition, and continued operation could worsen damage to the inverter board or compressor motor. Leave the washer unplugged until the fault is diagnosed and repaired.

A reset may temporarily clear the error code display, but it will not resolve the underlying fault. If the inverter board or its power supply has a real problem, error 335 will return once the washer attempts to operate again. A proper repair requires diagnosing and correcting the root cause before the error will stay cleared.

Some causes of error 335 are DIY-friendly, such as checking the power outlet voltage, reseating the CN8 connector, or inspecting wiring for obvious damage. However, if the inverter board itself has failed, replacing it involves working with internal components and requires comfort with appliance disassembly. Homeowners unfamiliar with electrical diagnostics should consider calling a qualified technician.

Repair costs vary depending on the root cause. If the fix involves only reseating a connector or addressing a power supply issue, costs may be minimal. If the inverter board requires replacement, parts alone typically range from $100 to $300 or more, with additional labor costs if a technician is hired. A full diagnosis is needed before estimating total repair cost.