GE Washer Error Code 352

Error code 352 on a GE washer means the compressor discharge thermistor has detected a temperature at or above 212°F (100°C). This is a protective fault that shuts down the compressor to prevent damage from overheating. It is commonly caused by a clogged condensate drain line, restricted airflow, or a dirty condenser. The issue must be resolved before the affected function will resume normal operation.

No, you should not continue operating the machine with error code 352 active. The washer has detected that the compressor is running at or above a critical temperature threshold, and continued use risks permanent damage to the compressor. The control board has halted the affected function as a safety measure, and the underlying cause should be diagnosed and corrected before resuming normal use.

Repair costs vary widely depending on the cause. Clearing a clogged drain line or cleaning the condenser yourself costs little to nothing. A thermistor replacement, including the part and labor, typically falls in the range of $100 to $250. Compressor replacement is the most expensive scenario, often ranging from $400 to $700 or more depending on labor rates and parts availability. Getting a professional diagnostic first helps avoid unnecessary parts replacement.

Start by inspecting and clearing the condensate drain line, as a clog there is the most common trigger for this fault. Also check and clean the condenser coils and verify that all air intake and exhaust paths are unobstructed. If those steps do not resolve the error, the discharge thermistor may need to be tested or replaced. Persistent faults after those checks may point to a compressor issue requiring professional service.

A reset may temporarily clear the fault display, but the error will return if the underlying cause has not been corrected. Error code 352 is triggered by a real temperature condition measured by the discharge thermistor, so simply restarting the machine without addressing the root cause will typically result in the fault reappearing during the next cycle. Fix the cause first, then reset the unit.