Error code reference

Hotpoint Washer Error Code E35

Fault in wiring/connection between control module and chopper module.

First step from the service manual

Check wiring and connections to chopper module.

The complete diagnostic procedure includes additional test steps, resistance specifications, wiring diagram references, and component test points.

MyPros+ Max

Get the full diagnostic procedure for E35.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts from the OEM service manual
Verified part numbers when replacement is required

Get the full procedure

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Hotpoint Washer

E35 on my Hotpoint Washer

M+

Fault in wiring/connection between control

From Service Manual 300752, p.44:

1.Check wiring and connections to chopper module.

2.Measure control board supply voltage at the test points. Expected: 12 VDC and 5 VDC; a drop below 4.75 VDC on the logic rail points to a failed onboard regulator.

3.Inspect all connectors on the main control for corrosion, thermal stress, or backed-out pins. Reseat each connector with the power disconnected.

Part WR55X10942

Main control board

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass

First step from the service manual

Get the full diagnostic procedure for E35.

Related Hotpoint washer codes