Hotpoint Washer Error Code F16

F16 is listed as not applicable in Hotpoint's standard fault code definitions, meaning it does not correspond to a specific monitored component or system failure. It most commonly appears as a result of a transient electrical event or a control board anomaly. Confirming your exact model number is recommended, as code definitions can differ across Hotpoint washer generations.

Because F16 does not correspond to a defined fault, the washer may still function normally despite displaying the code. However, if the machine is not completing cycles, is behaving unusually, or the code appears alongside other errors, stop using it until the cause is identified. Running a machine with an unresolved control board fault can sometimes lead to further damage.

A power reset will clear transient or stored fault codes from the control board's memory, and this is the recommended first step. Unplug the washer for at least 5 minutes, then restore power. If F16 was caused by a temporary glitch, the reset should resolve it. If the code reappears after the reset, a deeper issue with the control board or its connections is likely present.

In many cases, yes. Start by unplugging the washer from the power outlet for 5 to 10 minutes, then plug it back in and run a short cycle to see if the code returns. If the code clears and the machine operates normally, no further action is needed. If it returns repeatedly, further diagnosis of the control board and wiring connections is needed.

If a simple power reset clears the code, the repair costs nothing. If a control board replacement is required, parts and labor can range from roughly $150 to $350 depending on the model and local labor rates. Getting a diagnosis from a qualified technician before ordering parts is advisable, since the code does not point to one specific component.