KitchenAid Washer Error Codes

16 error codes for KitchenAid washer models. Each links to the full diagnostic procedure from the service manual.

CodeDescription

F/07Motor Control Unit (MCU) error F/11Serial communication error F/13Dispenser circuit error F/22CCU / Touchpad / LED assembly error F/dLDoor lock error F02Long drain F05Water temperature sensor (NTC) error F06Drive motor tachometer error F09Overflow condition F10Motor Control Unit (MCU) heat sink thermal trip F14EEPROM error F15System leak detected F21Pressure switch failure FdUDoor unlock error FHNo water detected entering machine or pressure switch trip not detected after…SudSuds lock

MyPros+ Max

Get the full diagnostic procedure for any KitchenAid washer error code.

Step-by-step tests with expected resistance, voltage, and continuity values
Wiring diagram references and connector pinouts
Verified part numbers when replacement is required

Get started

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Washer

F/07 on my KitchenAid Washer

M+

Motor Control Unit (MCU) error - the main

From Tech Sheet W11491068, p.40:

1.Unplug washer or disconnect power, then check wire harness connections between the drive motor and the MCU, and between the MCU and the CCU.

2.Measure the drive motor winding resistance at the main control connector. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand and check for free rotation. Inspect the belt and pulley for glaze or wear; a slipping belt mimics a motor fault under load.

Part W10006384

Drive motor

Start diagnosing faster today.

$29/month · Cancel anytime · Or $9.95 3-day pass

Get started