Samsung Washer Error Code 1BC2

The 1BC2 code on a Samsung washer indicates a switch error involving the main relay on the upper washer unit. It means the control system has detected a switch that is jammed or stuck and cannot transition properly between states. This prevents the washer from operating normally. The fault can originate at the control panel, the switch assembly, the wiring, or the control board.

It is not recommended to continue using the washer while the 1BC2 error is active. A stuck or failed relay switch can prevent the machine from properly controlling power to its motor and other components, which could lead to further damage. Stop using the appliance and diagnose the fault before resuming normal operation.

A reset may temporarily clear the 1BC2 error code, but it will return if the underlying switch or relay fault has not been resolved. To reset, unplug the washer for several minutes and then restore power. If the code reappears immediately or after the next cycle, the physical or electrical cause must be diagnosed and repaired to permanently clear the fault.

Some causes of the 1BC2 error are accessible to a knowledgeable DIYer. Start by inspecting the control panel for any buttons that appear stuck, warped, or physically damaged. You can also check wiring connectors for looseness or visible damage. However, if the fault lies in the main relay switch or the control board itself, replacement of those components is typically required and may be better handled by a qualified technician.

Repair costs vary depending on the root cause. If only a control panel button or wiring connector is at fault, costs could range from minimal to around $50 to $150 for parts and labor. If the main relay switch assembly or control board needs replacement, costs can range from $150 to $400 or more depending on parts pricing and service rates in your area.