Samsung Washer Error Code 1DC

The 1DC error code on a Samsung washer indicates a door error on the upper washer unit, specifically that the door did not open after a door open operation was commanded. The control board expected confirmation from the door switch that the door had opened, but that confirmation was not received. This causes the washer to stop operation as a safety precaution until the door fault is resolved.

No, you should not attempt to run the washer while the 1DC error is active. This code indicates the upper door lock system is not functioning correctly, and operating the washer with an unconfirmed door state poses a risk of the door opening unexpectedly during a cycle. Resolve the door fault before resuming use.

Repair costs for the 1DC error depend on the root cause. Reseating a connector costs nothing beyond your time. Replacing a door switch or door lock actuator typically runs in the range of $50 to $150 for parts, plus labor if a technician is involved. A full control board replacement, if needed, can push total repair costs to $200 to $400 or more depending on your region and service rates.

Some causes of the 1DC error are DIY-friendly, such as reseating a loose terminal connection at the door lock switch connector or inspecting the wiring harness for visible damage. However, replacing the door switch or door lock actuator requires comfort working with appliance electrical components and some disassembly of the door panel. If you are unsure, contacting a qualified appliance technician is the safest approach.

A power reset by unplugging the washer for a few minutes may temporarily clear the code if the fault was caused by a transient electrical issue or a momentary poor connection. However, if the underlying cause is a failed door switch, damaged wiring, or a faulty actuator, the error will return. A reset alone is not a fix for a hardware fault.