Samsung Washer Error Code E8

The E8 error on a Samsung washer indicates an Abnormal Water Temperature Error. It occurs specifically during Delicate or Wool cycles when the water temperature is detected at 50 degrees Celsius or higher during the initial fill. The machine may also trigger this code if it detects an abnormal sensor frequency of 25.24 KHz, at which point it forces a 2-minute drain cycle to protect the load.

You should not continue running the washer while E8 is active on a Delicate or Wool cycle. Water at 50 degrees Celsius or above can damage sensitive fabrics that these cycles are specifically designed to protect. The washer's forced drain response is a protective measure, and it is best to resolve the fault before attempting another wash cycle.

Yes, swapped inlet hoses are one of the more common causes of E8. If the hot water supply hose is connected to the cold water inlet on the back of the washer, hot water will enter during cycles that require cool water. Checking and correcting the hose connections is a simple, no-cost fix that should be ruled out before replacing any parts.

Turning the POWER switch off is the first recommended step to clear the E8 code. After powering off, wait a moment and restart the machine. If the underlying cause is a temporary condition such as a brief spike in water temperature, the reset may resolve it. However, if the fault condition still exists, the error will return and component diagnosis will be necessary.

Repair costs depend on the faulty component. A temperature sensor replacement is typically a lower-cost repair, with parts ranging from around 15 to 50 dollars and labor adding 80 to 150 dollars depending on your area. An inlet valve replacement falls in a similar range. Control board replacement is the most expensive possibility, with parts alone often running 100 to 300 dollars or more before labor.