Whirlpool Oven Error Code E6

E6 on a Whirlpool oven means the control board has detected an open circuit on the CANCEL key drive line, reported under the F2 fault category. This indicates the board is not receiving a proper signal back from the CANCEL key in the keypad matrix. The cause is most often a worn membrane keypad or a loose ribbon cable connector between the keypad and the control board.

Operating the oven with an active E6 fault is not recommended. Because the CANCEL key circuit is open, you may not be able to reliably stop a cooking cycle using the Cancel button, which is a basic safety function. It is best to resolve the fault before resuming normal use.

If only the membrane keypad needs replacement, parts typically range from around $20 to $80 depending on the model, and the repair is relatively straightforward. If the control board is at fault, replacement boards generally range from $100 to $300 or more. Adding a professional technician's labor will increase the total cost, usually by $75 to $150 or more depending on your location.

Yes, in many cases this repair is approachable for a knowledgeable DIYer. Start by disconnecting power to the oven and firmly reseating the keypad ribbon cable connector. If the error returns, the membrane keypad itself is the most likely component to replace, and it is typically accessible from the front of the control panel after removing a few screws.

Disconnecting power for several minutes will clear the stored fault code, but the E6 error will return as soon as the oven powers back up if the underlying open circuit condition is still present. A reset is useful as part of diagnosis, particularly after reseating the keypad connector, but it is not a permanent fix for a failed keypad or damaged cable.