Whirlpool Range Error Code PF

PF stands for Power Failure. The electronic control board displays this code when it detects that power to the range has been interrupted and then restored, or when the unit is powered on for the first time. It is a notification, not a component fault. Press Cancel or Clock to clear it, then reset the clock.

Yes, the PF code does not indicate a safety hazard or a failed component. The range is fully operational once power is restored. You can cook normally after clearing the code. The only function affected is the clock and any previously programmed timed-cook settings, which you will need to re-enter.

In most cases, fixing PF costs nothing. Pressing Cancel and resetting the clock is all that is needed after a power outage or first-time installation. If the code is caused by a damaged power cord, replacement cords typically run $20 to $50 for parts. If a loose terminal block connection is found, a service call to have a technician inspect and tighten it generally costs $75 to $150 depending on your area.

Press the Cancel or Clock button to dismiss the PF code, then use the clock-setting controls to enter the correct time. The range should return to normal operation immediately. If PF keeps coming back without an obvious power outage, check the circuit breaker, inspect the power cord for damage, and verify the wall outlet's terminal connections are tight.

Recurring PF codes without a known outage typically point to an intermittent power supply problem. Check that the wall outlet is providing steady 240V, inspect the power cord for damage or loose connections at both ends, and verify the terminal block inside the range is secure. A loose connection at any of these points can cause momentary drops in power that the control board registers as a power failure.