Model reference

Fisher & Paykel WH2424P1

Washer

1 document20 error codes3 service modes

Available documentation

Service Manual

SERVICE MANUAL Front loading washing machine37 pg
Covers this model

MyPros+ Max

Diagnose your Fisher & Paykel WH2424P1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Fisher & Paykel Washer

CLr FLtr on my Fisher & Paykel WH2424P1

M+

Pump error; the water level has not

From Service Manual 673975, p.27:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drain pump winding resistance at connector J7. Expected: 12 to 16 ohms at room temperature.

3.Verify the board switches the pump at 120 VAC during the drain cycle.

Part W10876537

Drain pump assembly

Error codes (20)

CodeMeaning

CLr FLtrPump error; the water level has not changed in 6 minutes.Door openDoor is detected as not closed for longer than 20 seconds after the program has…E7:00The initial speed of the motor has been detected as being out of sync.E7:01Motor stall error; the motor control module has been unable to start the motor.E7:02Motor loss of phase; the motor control module has detected a loss of one of the…E7:03Motor over current; the motor control module has detected excessive current.E7:04Motor current sensing circuit is faulty.E7:06The supply voltage level has become too low to power the motor control module.E7:07The motor control module has detected the motor windings are over temperature.E7:08The motor control module has detected that the motor bridge electronics is over…E7:09The motor control module during its self-test routine has detected an error.Err 10Heater NTC has malfunctioned; displayed at the end of the program.Err 105Communication error between the motor control module and the display PCB.Err 12Water level has exceeded the flood protection level.Err 235The door lock has malfunctioned.Err 74Pressure sensor frequency is out of range.Err 75Heater failure; the water failed to reach the selected wash temperature.no tAPExpected water level not attained within 8 minutes; the machine has detected…Out OF bALLoad has been detected as not evenly distributed or uneven.Sud LOCToo many suds detected in the inner drum.

Service modes (3)

diagnostic1
model_id_setting1
showroom_mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass