mypros+
Model reference

Frigidaire CLCE600RW0

Washer

4 documents45 error codes2 service modes

Available documentation

Tech Sheet

  • Frigidaire Dryer Tech Sheet FFLE1011MW0 13753940040 pg
    Covers this model

Tech Tip

  • Tech Tip LNTT2521 Clutch Error EC61 pg
    Covers this model

Installation Guide

  • Installation of your Laundry Center64 pg
    Covers this model

Tech Data Sheet

  • Tech Data Sheet40 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire CLCE600RW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (45)

CodeMeaning
E00Washer no error codeE11Washer fill time too long.E21Washer water not pumping out fast enough.E31Moisture sensor faultE32Washer pressure sensor calibration problems.E35Washer pressure sensor indicates water overfill.E41Washer control board thinks lid switch is open.E42Washer lid lock device failure.E43Washer control board fails to lock lid.E44Washer lid closed sensing failure.E45Washer lid locked sensing failure.E46Washer lid lock command sensing failure.E49Washer lid incongruence between lid closed sensing and lid locked sensing.E4AWasher lid locked triac sensing failure on control board.E51Motor relay stuck open, locked rotor, harness fault, low power supply, thermal…E52Motor relay stuck closedE53Motor faultE54Centrifugal Switch 2 stuck open/closed, heater open or shorted to ground, or…E55Motor sensing failure on main boardE56Belt broken or loose.E57Washer high current on inverter.E58Washer high current on motor phase.E59Washer incongruence between real motor speed and expected motor speed.E5AWasher high temperature on heat sink on control board.E5CWasher voltage too high on control board.E61Heater relay failureE62Heating timeoutE65High limit thermostat trip count too highE67Heater sensing failure on main boardE71NTC failure
View all 45 error codes
E72NTC failureE75Washer valve NTC failure.E81Program selector/encoder faultE82Key-stuck errorE91Washer communication error between UI board and control board.E92Washer communication error between UI board and control board.E93Software configuration errorE94Software configuration errorE97Software configuration errorEA1Washer power supply frequency out of limits.EA2High line voltageEA3Low line voltageEA5Line amplitude sensing failure on main boardEAEWasher line safe relay sensing failure.EF1Washer clogged drain pump.

Service modes (2)

  • Dryer Diagnostic Mode (Factory Line-Test Mode)["1. Place Cycle Selector knob at Position 0 (12 o'clock).","2. Place Temperature Selector to…
  • Washer Diagnostic Mode["1. Knobs can be in any position.","2. If unit is unplugged, Cold Power On and do step 4. If…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax