Frigidaire Washer Error Code E67

E67 on a Frigidaire washer indicates a heater sensing failure on the main control board. The board's internal circuit responsible for monitoring the heating system has been detected as defective. This is not an external sensor or wiring fault; the problem is identified as originating inside the control board itself. Replacing the main control board is the recommended fix.

Running the washer with E67 active is not recommended. Because the heater sensing circuit has failed, the washer cannot reliably regulate water temperature during heated cycles. This could result in incomplete cycles, improper washing performance, or repeated error shutdowns. It is best to address the fault before resuming normal use.

A reset may temporarily clear the code, but E67 is caused by an internal board defect, so the error will almost certainly return once the washer attempts to run a cycle that involves heater sensing. A reset does not repair the underlying hardware fault. The only lasting resolution is replacement of the defective main control board.

A knowledgeable DIYer comfortable working with appliance electronics can replace the main control board after disconnecting power to the washer. The repair involves locating the board, disconnecting all wiring harnesses carefully, swapping in the new board, and reconnecting all connectors. If you are not comfortable working around electrical components, a professional technician is the safer choice.

The cost depends on whether you do the repair yourself or hire a technician. A replacement main control board for a Frigidaire washer typically ranges from around $100 to $250 or more depending on the specific model. Professional repair labor can add another $80 to $150 on top of the part cost. Getting a quote from a local appliance repair service is advisable before proceeding.