mypros+
Model reference

Frigidaire 137317800

Washer

1 document49 error codes4 service modes

Available documentation

Tech Sheet

  • Washer Tech Data Sheet16 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire 137317800.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (49)

CodeMeaning
E00No failure code experienced.E11Fill time too long.E13Water leak in tub or air leak in air bell.E21Water not pumping out fast enough.E25Recirculation Pump Relay Sense failure.E26Recirculation Pump Relay failure.E31Electronic pressure switch failure.E32Pressure sensor calibration problem.E35Pressure sensor indicates water overfill.E38Air trap clogged.E41Control board thinks the door switch is open.E42Door lock device failure.E44Door closed sensing failure.E45Line door sensing failure.E46Door command sense failure.E49Door incongruence between door line and door sense.E52Bad signal from tacho generator.E53Low voltage to Motor Control Board.E54Over speed condition on motor.E55Under speed condition on motor.E57High current on inverter.E58High current on motor phase.E59No tacho signal for 3 seconds.E5AHigh temperature on heat sink caused by overloading.E5CHigh voltage experienced by Motor Control board.E5DCommunication problem between main control board and motor control board.E5FMotor Control is continuously resetting.E67Heater sensing relay failure.E68Current leakage to ground on heater or fuse opened.E71Drum water NTC failure (tub heater thermistor).
View all 49 error codes
E74Wash temperature does not increase.E91Communication error between UI board and main control board.E92UI to Main Board communications error.E93Console or Main Board control problem.E94Main Board control problem.E97Console or Main Board control problem.E98Console control problem.E9BCommunication problem between microprocessor and external EEPROM.E9FCommunication protocol error.EA1Power supply frequency out of limits.EA2Power supply voltage too high.EA3Power supply voltage too low.EA5Main voltage sensing failure.EAELine safe relay sensing failure.EF1Clogged drain pump.EF2Too much soap detected.EF5Incorrect water temperature.EF6Control Reset.EF8Key stuck on console.

Service modes (4)

  • Clear Error Codes["With the control on, press the 'power' button to enter standby mode.","Within 10 seconds after…
  • Diagnostic Mode["With the control on, press the 'power' button to enter standby mode.","Within 10 seconds after…
  • Installation Cycle["Make sure all articles are out of the drum (drum is empty).","Wake the washer up by pressing…
  • Read Error Codes["Wake the washer by pressing any button (except cancel).","Press and hold the 'power' and…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax