mypros+
Model reference

Frigidaire FAFW3801LW

Washer

7 documents44 error codes3 service modes

Available documentation

Tech Sheet

  • Tech Sheet FAFW3801LW16 pg
    Covers this model
  • Top Load Washer Product Specification Sheet3 pg
    Covers this model

Service Flash

  • Washer Control Will Not Change Soil Levels or Enter The Clean Cycle1 pg
    Covers this model
  • Service Flash LN1103 Washer Control Will Not Change Soil Levels or Enter The Clean Cycle1 pg
    Covers this model
  • Door Sags Slightly To Door Lock2 pg
    Covers this model
  • Frigidaire Washer LN063 Error Message Displayed Continuously1 pg
    Covers this model

Quick Reference

  • Failure Code Chart Frigidaire Affinity Washer2 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire FAFW3801LW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (44)

CodeMeaning
E11Fill time too long.E13Water leak in tub or air leak in air bell.E21Water not pumping out fast enough.E31Electronic pressure switch failure.E32Pressure sensor calibration problem.E35Pressure sensor indicates water overfill.E38Air trap clogged.E41Control board thinks the door switch is open.E43Door PTC circuit problem.E45Line door sensing failure.E47Door PTC sensing open.E48Door PTC sensing closed.E4ADoor PTC sensing problem.E52Bad signal from tacho generator.E53Low voltage to motor control board.E54Over speed.E55Under speed.E57High current on inverter.E58High current on motor phase.E59No tacho signal for 3 seconds.E5AHigh temperature on heat sink caused by overloading.E5CHigh voltage experienced by motor control.E5DCommunication problem between main control board and motor control board.E5FMotor control is continuously resetting.E67Heater sensing relay failure.E68Current leakage to ground on heater or fuse opened.E71Drum water NTC failure (tub heater).E75Water temperature sensor circuit.E91Communication error between UI board and main control board.E92UI to main board communications error.
View all 44 error codes
E93Console or main board control problem.E94Main board control problem.E97Console or main board control problem.E98Console control problem.E9FCommunication protocol error.EA1Power supply frequency out of limits.EA2Power supply voltage too high.EA3Power supply voltage too low.EA5Main voltage sensing failure.EAELine safe relay sensing failure.EF1Clogged drain pump.EF2Too much soap.EF6Control reset.EF8Key stuck.

Service modes (3)

  • Clear Error Code["Turn the Program Knob to the start position of the cycle furthest to the left.","Press…
  • Diagnostic Test["Turn the Program Knob to the start position of the cycle furthest to the left.","Press…
  • Read Error Codes["Wake the washer by pressing any button.","Wait 5 seconds.","Press and HOLD the Start/Pause and…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax