Model reference

Frigidaire FFLG1011MW1

Washer

2 documents45 error codes2 service modes

Available documentation

Service Manual

Use & Care of your Laundry Center22 pg
Covers this model

Tech Sheet

Frigidaire Dryer Tech Sheet FFLE1011MW0 13753940040 pg
Covers this model

MyPros+ Max

Diagnose your Frigidaire FFLG1011MW1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Frigidaire Washer

E00 on my Frigidaire FFLG1011MW1

M+

Washer no error code — no failure

From Service Manual 708359, p.51:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part 5304504863

Electronic control board

Error codes (45)

CodeMeaning

E00Washer no error code E11Washer fill time too long.E21Washer water not pumping out fast enough.E31Moisture sensor fault E32Washer pressure sensor calibration problems.E35Washer pressure sensor indicates water overfill.E41Washer control board thinks lid switch is open.E42Washer lid lock device failure.E43Washer control board fails to lock lid.E44Washer lid closed sensing failure.E45Washer lid locked sensing failure.E46Washer lid lock command sensing failure.E49Washer lid incongruence between lid closed sensing and lid locked sensing.E4AWasher lid locked triac sensing failure on control board.E51Motor relay stuck open, locked rotor, harness fault, low power supply, thermal…E52Motor relay stuck closed E53Motor fault E54Centrifugal Switch 2 stuck open/closed, heater open or shorted to ground, or…E55Motor sensing failure on main board E56Belt broken or loose.E57Washer high current on inverter.E58Washer high current on motor phase.E59Washer incongruence between real motor speed and expected motor speed.E5AWasher high temperature on heat sink on control board.E5CWasher voltage too high on control board.E61Heater relay failure E62Heating timeout E65High limit thermostat trip count too high E67Heater sensing failure on main board E71NTC failure

View all 45 error codes

E72NTC failure E75Washer valve NTC failure.E81Program selector/encoder fault E82Key-stuck error E91Washer communication error between UI board and control board.E92Washer communication error between UI board and control board.E93Software configuration error E94Software configuration error E97Software configuration error EA1Washer power supply frequency out of limits.EA2High line voltage EA3Low line voltage EA5Line amplitude sensing failure on main board EAEWasher line safe relay sensing failure.EF1Washer clogged drain pump.

Service modes (2)

Dryer Diagnostic Mode (Factory Line-Test Mode)["1. Place Cycle Selector knob at Position 0 (12 o'clock).","2. Place Temperature Selector to…
Washer Diagnostic Mode["1. Knobs can be in any position.","2. If unit is unplugged, Cold Power On and do step 4. If…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass