Model reference

GE GSD2200Z

Dishwasher

5 documents16 error codes4 service modes

Available documentation

Service Manual

Technical Service Guide "2" Model Dishwashers31 pg
Covers this model
GE Dishwasher Mini Manual GSD2200 GSD24002 pg
Covers this model

Bulletin

Dishwasher Cycle Selector Switches1 pg
Covers this model

Training

TECHNICAL SERVICE GUIDE MODEL DISHWASHERS Profile Performance Series31 pg
Covers this model

Other

Technical man GSD2200103 pg
Covers this model

MyPros+ Max

Diagnose your GE GSD2200Z.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·GE Dishwasher

C1 on my GE GSD2200Z

M+

Pump out portion of the cycle takes

From Service Manual 136058, p.30:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drain pump winding resistance at connector J7. Expected: 12 to 16 ohms at room temperature.

3.Verify the board switches the pump at 120 VAC during the drain cycle.

Part WD19X23874

Drain pump assembly

Error codes (16)

CodeMeaning

C1Pump out portion of the cycle takes longer than 95 seconds (Blocked Drain…C2Drain over 405 seconds; total pump out time exceeded 405 seconds C3Dishwasher will not go into pump out; the control did not receive an electrical…C4Dishwasher is in an overfill condition; the machine has overfilled or the flood…C5Dishwasher experiences a short drain period; the drain solenoid is energized…C6Water temperature does not reach correct temperature even after maximum…C7Water temperature sensor circuit is inoperative; the thermistor is disconnected…C8Detergent cup is blocked from opening fully (GSD2800D only).CLEAN FLASHINGControl error on Profile models indicated by flashing CLEAN LED and beeping…DRYING FLASHINGControl error on Profile Performance models indicated by flashing DRYING LED…NORMAL FLASHINGControl error on Profile models indicated by flashing NORMAL LED and beeping…PFA power failure has occurred in the consumer's home; the cycle selection last…RINSING FLASHINGControl error on Profile Performance models indicated by flashing RINSING LED…SENSING OFFCleanSensor error START RESET FLASHINGNormal indication on Profile models that the START/RESET pad has been pressed…WASHING FLASHINGSTART/RESET pad has been pressed on Profile Performance models, indicating the…

Service modes (4)

F-1 Test Cycle (GSD2200/2400)["Close detergent cup and latch door.","Press the two hidden F-1 test cycle pads at the same time
F-1 Test Cycle (GSD2600/2800)["Close detergent cup and latch door.","Press the two hidden F-1 test cycle pads at the same time
F1 Test Cycle["Close detergent cup and add hot water.","Press POTS & PANS and NORMAL WASH keypads at the same…
F1 Test Freeze Capability["While F1 test cycle is running, press the HEATED DRY keypad to pause on the current test…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass