mypros+
Model reference

GE ZISS480DXASS

Refrigerator

12 documents35 error codes3 service modes

Available documentation

Service Manual

  • Technical Service Guide131 pg
    Covers this model

Wiring Diagram

  • Wiring Diagram3 pg
    Covers this model

Bulletin

  • Monogram Side-by-Side Dispenser Freezer Door Replacement3 pg
    Covers this model
  • Monogram SXS Dispenser Models - Auger Motor Stalling1 pg
    Covers this model
  • Service Bulletin REF 18-03 - Refrigerators Built-In Side-By-Side Models Fresh Food Too Cold2 pg
    Covers this model
  • Icemaker Fill Tube Freeze Repair4 pg
    Covers this model
  • Service Bulletin - Refrigerator Mullion Condensation2 pg
    Covers this model
  • Service Bulletin - MONOGRAM SXS DISPENSER MODELS - AUGER MOTOR STALLING1 pg
    Covers this model
  • Monogram Refrigerator Dispenser Auger Motor Boot1 pg
    Covers this model

Training

  • Built-in SXS Refrigerators Icemaker Operation and Diagnosis Training Bulletin TB06-17 Rev 11 pg
    Covers this model
  • Monogram SxS Refrigerators Express Chill Reference Guide6 pg
    Covers this model

Installation Guide

  • Monogram Refrigerator Mullion Condensation2 pg
    Covers this model
MyPros+ Max

Diagnose your GE ZISS480DXASS.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
0001FF1 thermistor reading out of range.0002FF2 thermistor reading out of range.0003FZ thermistor reading out of range.0004FZ evaporator thermistor reading out of range.0008Ambient temperature thermistor reading out of range.0013Quick Chill thermistor reading out of range.0100FZ fan feedback missing when fan is running.0101FZ fan feedback present when fan is off.0102FZ fan cannot reach target speed.0200FZ defrost heater timed out, 45-minutes of defrost on time (check FZ evaporator…0202Five consecutive FZ abnormal defrosts.0300Compressor ran continuously for 24-hours.0301Temperature satisfied > 3-hours (no compressor operation).0302FF temperature below freezing.0303FF temperature exceeds 20°F over setpoint, 1-hour post defrost or door opening.0304FZ temperature exceeds 20°F over setpoint, 1-hour post defrost or door opening.0307Damper driver fault (this fault code not available on some software versions).0400Dispenser Paddle Switch pressed > 7-minutes.0401Main control board software fault.0403Main control board hardware fault.0404Main control board hardware fault.0651Icemaker Harvest Extended > 10-minutes.0652Icemaker Harvest Extended 3 out of 10 harvests.0653Icemaker Harvest Not Completed after 30-minutes.0654Icemaker no water supply detected (this fault code not available on some…0655Icemaker Mold Heater not heating.0700Stuck keys on dispenser boards.0701Stuck keys on internal temperature board.0703Key press on temperature board while door is closed.0713FF door open for 15-minutes continuously.
View all 35 error codes
0714FF door open for 60-minutes total in the last 24-hours.071550 FF door openings in the last 24-hours.0717FZ door open for 15-minutes continuously.0718FZ door open for 60-minutes total in the last 24-hours.071950 FZ door openings in the last 24-hours.

Service modes (3)

  • Demo ModePress the Freezer colder ('-') and the Refrigerator warmer ('+') pads simultaneously for 5-seconds.
  • Sabbath ModePress and hold the Freezer colder ('-') and warmer ('+') pads at the same time and hold for…
  • Service Mode (Diagnostic Mode)Press both freezer temperature pads (+ and -) and the refrigerator temperature pads (+ and -)…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass