Model reference
GE GFWS1705H
Washer
3 documents27 error codes16 service modes
Available documentation
Service Manual
- ServiceManual 31 926170 pg
- GE Appliances Front Load Washer Technical Service Guide70 pg
- Service Technician Only - Diagnostic Guide8 pg
MyPros+ Max
Diagnose your GE GFWS1705H.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (27)
CodeMeaning
E22Fill timeoutE23Flood protect drainE31Drain timeoutE38Dispenser errorE39Dispenser timeoutE42Drive motor instantaneous currentE45No speed feedbackE46Drive motor over temperatureE47Heat sink over temperatureE48Drive motor openE4AUnder voltsE4BPower up problemsE4COver voltsE50Drive/Control interface systemE52Main control wake-up errorE54No motor responseE56Electronic control checksum failureE57Communication failureE58Main control board non-recoverable error.E60Door lock switch failureE61Door unlock and main control switch failureE62System contact failureE63Unexpected open doorE64Unexpected open door while runningE65Water level sensor failureE66Water temperature sensor open.E67Water temperature sensor shorted.Service modes (16)
- Control Board Programming (t01)1
- Service Test Mode1. Washer must be in idle mode (all LEDs on display off). 2. Press one of the following key…
- Service/Diagnostic ModeWithin 30 seconds of plugging in the washer, alternately press the Temp button and the Delay Wash…
- t01 - Model IDFrom service test mode, press Start/Pause
- t02 - Fault CodesFrom service test mode, navigate to t02 and press Start/Pause
- t03 - Software IDFrom service test mode, navigate to t03 and press Start/Pause to alternate between UL (UL code)…
- t04 - LED Illumination and Button TestFrom service test mode, navigate to t04 and press Start/Pause.
- t05 - Pump TestFrom service test mode, navigate to t05 and press Start/Pause.
- t06 - Water Level Sensor TestFrom service test mode, navigate to t06 and press Start/Pause
- t07 - Thermistor/Heater TestFrom service test mode, navigate to t07 and press Start/Pause.
- t08 - Steam TestFrom service test mode, navigate to t08 and press Start/Pause.
- t09 - Spray TestFrom service test mode, navigate to t09 and press Start/Pause.
- t10 - Tumble TestFrom service test mode, navigate to t10 and press Start/Pause.
- t11 - Spin TestFrom service test mode, navigate to t11 and press Start/Pause
- t12 - Dispenser TestFrom service test mode, navigate to t12 and press Start/Pause to advance
- t13 - EOL TestFrom service test mode, navigate to t13 and press Start/Pause.
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass