Model reference
GE WCVH6800
Washer
7 documents65 error codes3 service modes
Available documentation
Service Manual
- GE Front Load Washer Service Manual WCVH6800 31 913561 pg
- GE WCVH6800 Mini Manual6 pg
- H & U Washer Minimanual6 pg
- H & U Washer Service Manual6 pg
Tech Sheet
- H & U Washer Technical Service Sheet6 pg
- GE Washer Tech Sheet GCVH62606 pg
Job Aid
- Procedure for Programming the GE Front Load Washer Control1 pg
MyPros+ Max
Diagnose your GE WCVH6800.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (65)
CodeMeaning
22Fill problem detected by the control.23Fill problem detected by the control (requires solenoid valve assembly…30Drain problem detected by the control.31Drain problem detected by the control.38Dispenser mechanism problem.39Dispenser mechanism problem.42Motor drive operation above design limits.43Motor drive internal problem.45Motor drive operation above design limits.49Motor drive operation above design limits.4AMotor drive internal problem.4BMotor drive internal problem.4CMotor drive internal problem.4EMotor drive internal problem.4FMotor drive internal problem.50Motor drive internal problem.52Motor drive internal problem.53Motor drive internal problem.54Motor drive internal problem.57Motor drive internal problem.58Motor drive internal problem.60Main control internal problem.61Main control internal problem.62System contact failure.63Door lock assembly problem.64Door lock assembly problem.65Water level sensor problem.66Water temperature sensor problem.67Water temperature sensor problem.70Stuck key detected on control panel.View all 65 error codes
71Motor drive internal problem.E22Fill timeoutE23Flood protect drainE30Drain pump not presentE31Drain timeoutE38Dispenser errorE39Dispenser timeoutE42Drive motor instantaneous excess current draw.E43DC FaultE45Drive motor overload currentE46Drive motor over temperatureE47Heat sink over temperatureE48Drive motor openE49Drive motor overload powerE4AUnder voltsE4BOver voltsE4COver voltsE4EUnder volts after startE4FEEProm faultE50Motor drive internal problem.E52Main control wake-up errorE53Buffer errorE54No motor responseE57Checksum failureE58Communication failureE60Door lock switch failureE61Door unlock switch failureE62System contact failureE63Unexpected open doorE64Unexpected open door while runningE65Water level sensor failure (foam)E66Water temperature sensor open.E67Water temperature sensor shorted.E70Stuck keyE71Key fault
Service modes (3)
- Control Board Programming (t01)1
- Service Test Mode["Press POWER button to clear any current cycles (display must be blank).","Disconnect the power…
- Service/Diagnostic ModeWithin 30 seconds of plugging in the washer, press Signal, then Delay, then Signal, then Delay.
Full entry steps, exit procedures, and test sequences are available in Max.
Related GE washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass