mypros+
Model reference

Jenn-Air JDB8200AWP3

Dishwasher

9 documents32 error codes7 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10321875 - Rev B (FR)2 pg
    Covers this model
  • Tech Sheet12 pg
    Covers this model
  • KitchenAid KDTE334D Dishwasher Tech Sheet12 pg
    Covers this model
  • TechSheet W10455258 RevA FR2 pg
    Covers this model
  • Jennair Dishwasher JDB8500AWX3 W10455257 Tech Sheet2 pg
    Covers this model

Service Flash

  • ServicePointer W10547922 RevA Dishwasher OutletHoseClampReplacementKit3 pg
    Covers this model

Tech Tip

  • Instruction Sheet2 pg
    Covers this model

Installation Guide

  • Installation Instructions56 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air JDB8200AWP3.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
1-1Control detected pilot relay K400 stuck closed.1-2Control software issue10-1Dispenser electrical problem10-2Vent wax motor electrical problem10-3Drying fan error2-1Control detected stuck key(s) in keypad or keypad connection.2-2User Interface cannot communicate with main control3-1Open connector or component in temperature sensing circuit (open or faulty…3-2Shorted connection or component in temperature sensing circuit, or incoming…3-3OWI (optical soil sensor) failed calibration.3-4OWI failed calibration4-1Wash motor no communication4-2Wash Motor4-4Wash motor failure5-1Door stuck open5-2Door stuck closed6-1Low or no water to dishwasher (mechanical problem).6-2Fill valve electrical problem6-3Suds or air detected in pump.6-4Float switch stuck in overfill (open) position and/or dishwasher not level.6-6Incoming water temperature under 65°F (29°C)6-8Inlet Water7-1No heat7-2Heater stuck on8-1Slow drain8-2Draining8-3Draining8-4Drain motor electrical problem9-1Diverter can't find position9-2Diverter stuck on
View all 32 error codes
9-3Diverter disk in sump is missing.9-4Lower spray arm error

Service modes (7)

  • Clear Customer Error History["Enter Service Diagnostics Cycle.","During the appropriate diagnostics interval (interval with Hi…
  • Error Code Display (within Service Diagnostics)After entering Service Diagnostics Cycle, errors are displayed in intervals 25-22. Interval 27
  • Rapid Advance (Customer Cycle)After starting a customer cycle, press HIGH TEMP
  • Rapid Advance ModeAfter starting a cycle, press HI TEMP
  • Rapid Advance Mode (Cycle Operation)["With door open or closed after starting a cycle, press HIGH TEMP
  • Sales Demo Mode ClearRun Service Diagnostics Cycle to clear Demo mode.
  • Service Diagnostics Cycle1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass