mypros+
Model reference

Jenn-Air JDB9000CWS3

Dishwasher

5 documents27 error codes7 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10880571 - Rev A (FR)16 pg
    Covers this model
  • KDTE104ESS3 Tech Sheet12 pg
    Covers this model
  • Tech Sheet12 pg
    Covers this model
  • Fiche technique W10751168C16 pg
    Covers this model

Tech Tip

  • Instruction Sheet2 pg
    Covers this model
MyPros+ Max

Diagnose your Jenn-Air JDB9000CWS3.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (27)

CodeMeaning
1-1Control detected K2 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem10-3Drying fan error2-1Control detected stuck key(s) in keypad or keypad connection.2-2No response from user interface3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Incoming water temperature above 167°F (75°C), or shorted connection/component…3-3OWI calibration failure4-3Wash motor not running due to loose connection in Motor circuit and/or faulty…5-1Door stuck open5-2Door stuck closed6-1Low/no water6-2Fill valve electrical problem6-3Suds or air in pump6-4Float switch open6-6Incoming water under 84°F (29°C)6-7Disconnected or damaged flowmeter.6-8Regen valve electrical problem7-1No heat7-2Heater stuck on8-1Slow drain8-2Drain motor electrical problem8-3Drain stuck on9-1Diverter can't find position9-2Diverter stuck on9-3Diverter disk missing

Service modes (7)

  • Customer Program Fast Forward ModeAfter starting a customer program, press HI TEMP
  • Demonstration Mode DeactivationRun the Service Diagnostic Program to deactivate demonstration (showroom) mode.
  • Error Code History RetrievalSame as Service Diagnostic Program entry (1-2-3-1-2-3-1-2-3 key sequence)
  • Rapid Advance (Customer Cycles)["Start a customer cycle.","Press HIGH TEMP
  • Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
  • Service Diagnostic ProgramIn standby mode
  • Service Diagnostics Cycle["Press Start key to wake up the control panel.","Press any 3 keys in the sequence…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass