Model reference

Jenn-Air W10455257A

Dishwasher

1 document30 error codes2 service modes

Available documentation

Tech Sheet

Jennair Dishwasher JDB8500AWX3 W10455257 Tech Sheet2 pg
Covers this model

MyPros+ Max

Diagnose your Jenn-Air W10455257A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Jenn-Air Dishwasher

1-1 on my Jenn-Air W10455257A

M+

Control detected K400 pilot relay stuck

From Tech Sheet W10496227, p.39:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (30)

CodeMeaning

1-1Control detected K400 pilot relay stuck closed.1-2Damaged or corrupted memory on control board or incompatible software…10-1Dispenser electrical problem 10-2Vent wax motor electrical problem (not all models)10-3Drying fan error (on models with fan)2-1Control detected stuck key(s) in keypad or keypad connection.2-2No response from user interface; User Interface cannot communicate with main…3-1Open thermistor/OWI temperature sensing circuit 3-2Shorted thermistor/OWI temperature sensing circuit 3-3OWI (optical soil sensor) failure or failed calibration.4-2Motor problems force cycle to start and stop repeatedly.4-4Wash motor failure 5-1Door switch stuck open 5-2Door switch stuck closed 6-1Low water or no water (mechanical problem)6-2Fill valve electrical problem 6-3Suds or air in pump 6-4Float switch open 6-6Fill valve triac on control shorted, or fill valve mechanically stuck open.6-8Rinse aid dispenser problem (for models with water softener 7-1No heat 7-2Heater stuck on 8-1Slow drain 8-2Drain motor electrical problem 8-3Drain motor electrical problem 8-4Drain motor electrical problem 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disk missing 9-4Diverter problem (general).

Service modes (2)

Rapid Advance Mode["After starting a cycle, press HI TEMP
Service Diagnostics Cycle["Press Start key to wake up control panel.","Press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Jenn-Air dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass