mypros+
Model reference

Kenmore 11028102310

Washer

3 documents33 error codes11 service modes

Available documentation

Service Manual

  • Kenmore Oasis Washer Service Manual61 pg
    Covers this model
  • Cabrio™ Automatic Washer Job Aid84 pg
    Covers this model
  • Vertical Modular Washer84 pg
    Covers this model
MyPros+ Max

Diagnose your Kenmore 11028102310.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (33)

CodeMeaning
dLDoor Lid Lock FailureF0 E2Over suds condition detectedF0 E4High water temperature during rinse cycleF0 E5Off balance load detected.F1 E1Main control fault.F1 E2Motor control faultF2Keypad/user interface faultF2 E1Stuck keyF2 E3Mismatch of main control and UIF3 E1Pressure sensor faultF3 E2Inlet water temperature faultF5Water temperature sensing faultF5 E1Lid switch faultF5 E2Lid lock faultF5 E3Lid unlock faultF5 E4Lid not opened between cyclesF52Motor rotor position sensor (RPS) faultF53Motor phase current sensing faultF54Motor control over-current faultF7Motor speed sensing faultF7 E1Basket speed sensor faultF7 E5Shifter faultF7 E6Motor faultF7 E7Motor unable to reach target RPMF8 E1No fill / long fillF8 E3Overflow conditionF8 E5Hot and cold water supply hoses are reversed.F9 E1Long drainLdLong DrainLFLong Fill
View all 33 error codes
lidLid open conditionoLOverloadeduLUnbalanced Load

Service modes (11)

  • Automatic Diagnostic Test Mode["Ensure washer is in standby mode (plugged in with all indicators off, or with only the Clothes…
  • Automatic Test Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Spin' LED is On and '02' is…
  • Calibration Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Rinse' LED is On and '04' is…
  • Console and Indicators Diagnostic Test Mode["Plug in washer or reconnect power.","From Standby (Off) Mode, press and release (key-dance)…
  • Fault Code Display Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Done' LED is On and '01' is…
  • Manual Diagnostic Test Mode["Ensure washer is in standby mode (plugged in with all indicators off, or with only the Clothes…
  • Manual Test Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Spin & Done' LEDs are On and…
  • Sales Demo Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Rinse & Done' LEDs are On and…
  • Service Diagnostic Mode Entry["Ensure washer is in standby mode (plugged in with all indicators off).","RESET
  • Software Version Display Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Rinse, Spin, and Done' LEDs are…
  • UI Test Mode["Enter Service Diagnostic Mode.","Turn cycle selector knob until 'Rinse & Spin' LEDs are On and…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Kenmore washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax