mypros+
Model reference

Maytag MAH4000BWQ

Washer

35 documents8 error codes12 service modes

Available documentation

Service Manual

  • Instruction Sheet8 pg
    Covers this model
  • New Century Neptune Washer Service Manual Supplement52 pg
    Covers this model

Bulletin

  • Technical Bulletin - ITDL-0026-B Bleach Vapors1 pg
    Covers this model
  • Technical Bulletin - TDL-0045A-B Washer vibrates and walks during the spin cycle1 pg
    Covers this model
  • Technical Bulletin TDL-0045A-B1 pg
    Covers this model
  • Technical Bulletin - Washer vibrates and walks during the spin cycle1 pg
    Covers this model
  • Technical Bulletin - ITDL-0026-B Bleach Vapors1 pg
    Covers this model
  • Technical Bulletin - Bleach Vapors1 pg
    Covers this model
  • Corrugated Drain Hose - Introduced1 pg
    Covers this model
  • Technical Bulletin - TDL-0046A-B Rubber cuff removed on drain hose1 pg
    Covers this model
  • Technical Bulletin - TDL-0046A-B Rubber cuff removed on drain hose1 pg
    Covers this model
  • Technical Bulletin - Rubber cuff removed from drain hose1 pg
    Covers this model
  • Technical Bulletin - TDL-0052A-B Failed resistor on control board2 pg
    Covers this model
  • TS Bulletin 675 - Pre-Attached Rubber Feet1 pg
    Covers this model
  • Laundry TubCover - Revision1 pg
    Covers this model
  • Driven Pulley Mounting Bolt - Revised1 pg
    Covers this model
  • HNP106 Software Updates1 pg
    Covers this model
  • Technical Bulletin - TDL-0052A-B Failed resistor on control board2 pg
    Covers this model
  • Technical Bulletin - TDL-0051A-B Door boot wrinkles2 pg
    Covers this model
  • Technical Bulletin - Door boot wrinkles2 pg
    Covers this model
  • LAUNDRY Pump - Revised1 pg
    Covers this model
  • Service Bulletin - TS635 (New Machine Control Board - HNP106)2 pg
    Covers this model
  • Service Bulletin - TS602 (Corrugated Drain Hose)1 pg
    Covers this model
  • Door Boot Gasket - Revised1 pg
    Covers this model
  • Technical Bulletin - Maytag Neptune Burnt Resistors2 pg
    Covers this model
  • Stops in Mid-Cycle3 pg
    Covers this model
  • Technical Bulletin - Improved Lip Seal2 pg
    Covers this model
  • Technical Bulletin1 pg
    Covers this model
  • TechnicalBulletin-TDL-0044B-B1 pg
    Covers this model
  • Technical Bulletin - Motor Drive System Neutral Feed Issue1 pg
    Covers this model

Service Flash

  • Introduction of New Software3 pg
    Covers this model
  • RT26141 Software enhancement5 pg
    Covers this model

Other

  • searsrt26 134 01 11 052 pg
    Covers this model
  • TS6031 pg
    Covers this model
  • TCL 0015B B1 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MAH4000BWQ.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (8)

CodeMeaning
FLDoor fails to lock after 11 attempts.LODoor fails to unlock after 11 attempts.LrLocked rotorndNo drainnFNo fillodDoor switch was not seen open since the last final spinPFPower failure detectedsdSuds detected

Service modes (12)

  • Advertising Mode (LCD Washer - MAH7500A)Press and hold the Favorites and Back keys simultaneously for 3 seconds.
  • Advertising Mode (LED Washer - MAH5500B)Press and hold the Heavy Soil and Cotton/Sturdy keys simultaneously for 3 seconds.
  • Board Input Test (LED Washer)Enter Service Mode, then press the Hand Wash key.
  • Board Output Test (LED Washer)Enter Service Mode, then press the Rinse key.
  • Membrane Pad Check (LED Washer)Enter Service Mode, then press the Wrinkle Free key.
  • Quick Service Cycle (LED Washer)Enter Service Mode, then press the Delicates key.
  • Quick Spin Test (LCD Washer)Enter Service Mode, select Service Tests, then select Quick Spin Test and press start quick spin…
  • Quick Spin Test (LED Washer)Enter Service Mode, then press the Spin key.
  • Service Mode (LCD Washer - MAH7500A)Press and hold the Back and Help keys simultaneously for 5 seconds.
  • Service Mode (LED Washer - MAH5500B)Press and hold the Delicates and Heavy Soil keys simultaneously for 3 seconds.
  • System Check (LCD Washer)Enter Service Mode, select Service Tests, then select System Check.
  • User Interface Test (LCD Washer)Enter Service Mode, select Service Tests, then select User Interface Test.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass