mypros+
Model reference

Whirlpool WDF560SAFM1

Dishwasher

6 documents25 error codes8 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10880571 - Rev A (FR)16 pg
    Covers this model
  • Tech Sheet W11427956A16 pg
    Covers this model
  • KDTE104ESS3 Tech Sheet12 pg
    Covers this model
  • Tech Sheet W10904613 RevB68 pg
    Covers this model

Wiring Diagram

  • KDTE204ESS4 Wiring Diagram W10921454 RevA2 pg
    Covers this model

Tech Tip

  • Instruction Sheet2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WDF560SAFM1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
1-1Control detected K1 pilot relay stuck closed.1-2Control software issue10-1Dispenser electrical problem10-3Drying fan error2-1Stuck key detected2-2No response from User Interface (UI)3-1Thermistor/OWI open3-2Thermistor/OWI shorted3-3Thermistor/OWI failed calibration4-3Wash motor not running5-1Door switch stuck open5-2Door switch stuck closed6-1Inlet water low/no water (mechanical problem)6-2Fill valve electrical problem6-3Suds/air in pump6-4Float switch open6-7Flowmeter disconnected or damaged.6-8Regeneration solenoid valve electrical problem7-1No heat7-2Heater stuck on8-2Drain motor electrical problem8-3Drain stuck on9-1Diverter can't find position9-2Diverter stuck on9-3Diverter disc missing

Service modes (8)

  • Customer Program Fast Forward ModeAfter starting a customer program, press HI TEMP
  • Demonstration Mode DeactivationRun the Service Diagnostic Program to deactivate demonstration (showroom) mode.
  • Error Code History RetrievalSame as Service Diagnostic Program entry (1-2-3-1-2-3-1-2-3 key sequence)
  • Rapid Advance (Customer Cycles)After starting a customer cycle, press HIGH TEMP
  • Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
  • Service Diagnostic CycleWhile in Standby, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second…
  • Service Diagnostic ProgramIn standby mode
  • Service Diagnostics CycleWhile in Standby mode, press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass