Model reference

Whirlpool WOES3030LS01

Oven

4 documents22 error codes1 service mode

Available documentation

Tech Sheet

Tech Sheet - W11600302 - Rev B2 pg
Covers this model

Service Flash

Installation Pointer - W11672734 - Rev A - Built In Single & Double Wall Oven Flush Installation9 pg
Covers this model
Service Pointer - W11815938 - Rev A - Wall Oven F8E0 Error Code6 pg
Covers this model

Quick Reference

Quick Start Guide3 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WOES3030LS01.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Oven

F1E1 on my Whirlpool WOES3030LS01

M+

Upper RTD (Resistance Temperature

From Tech Sheet W13660198, p.50:

1.Access service mode to confirm the active fault code and read stored error history.

2.Disconnect the sensor and measure resistance. Expected: 10 kΩ to 12 kΩ at 77°F (25°C).

3.Check the sensor harness for opens. A reading outside 5 kΩ to 50 kΩ indicates a failed sensor.

Part WP8577274

Temperature thermistor

Error codes (22)

CodeMeaning

F1E1Upper RTD (Resistance Temperature Detector) is uncalibrated.F1E2Lower RTD (Resistance Temperature Detector) is uncalibrated.F1E5Sensor usage out of range.F1E7PCB thermistor is open or shorted.F1E9WIDE queue full.F2E0Keypad is disconnected.F2E1Stuck keypad (a key is stuck or continuously pressed).F2E2Cancel or Off keypad error.F3E0Main oven sensor (upper) is open or shorted.F3E1Main oven sensor (lower) is open or shorted.F4E1Microwave oven magnetron thermistor is open or shorted.F4E4Microwave oven humidity sensor is open or shorted.F5E0Door and latch switches do not agree (mismatch between door and latch switch…F5E1Latch is not operating.F6E0Lost communication with microwave.F6E1Over temperature during cook mode.F6E2Over temperature during clean mode.F8E0Low fan speed underspeed (cooling fan running below minimum low-speed…F8E1Low fan speed overspeed (cooling fan running above maximum low-speed threshold).F8E2High fan speed underspeed (cooling fan running below minimum high-speed…F8E3High fan speed overspeed (cooling fan running above maximum high-speed…F9E0Miswired (incorrect wiring detected).

Service modes (1)

Service Diagnostic ModePress CANCEL > CANCEL > START (or OFF > OFF > ON) within 5 seconds.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool oven models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass