mypros+
Model reference

Whirlpool GS563LXSS1

Range

4 documents13 error codes6 service modes

Available documentation

Service Manual

  • GAS RANGE Use & Care Guide44 pg
    Covers this model

Tech Sheet

  • TECH SHEET - GS563LXSS1 WP Range8 pg
    Covers this model
  • FICHE TECHNIQUE - Tech Sheet W10041630 Rev A8 pg
    Covers this model
  • TECH SHEET - Whirlpool Gas Range GS563LXSS06 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool GS563LXSS1.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (13)

CodeMeaning
F1 E0EEPROM communications failure, likely caused by power line noise or lightning.F1 E1EEPROM checksum failure, likely caused by power line noise or lightning.F1 E3Fuel type (gas/electric) select failureF2 E0Key contact closed for more than 60 secondsF2 E1No communication between keyboard and controlF2 E6STOP/CLEAR key contact closed for more than 60 secondsF3 E0Break in oven sensor circuitF3 E1Short in oven sensor circuitF3 E2BAKE/BROIL temperature out of range (too high)F3 E3Clean temperature out of range (too high)F5 E0Door switch open during cleanF5 E1Door latch not operatingGoodNo failure

Service modes (6)

  • Manual Diagnostics Mode 1Within 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start key
  • Manual Diagnostics Mode 1 (Full - within 120 seconds of power-up)Within 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then START
  • Manual Diagnostics Mode 2After 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then Start key.
  • Manual Diagnostics Mode 2 (Limited - after 120 seconds of power-up)After 120 seconds of power-up, press Cancel/OFF, Cancel/OFF, then START
  • Temperature Adjustment (BAKE offset)Press and hold BAKE pad for 5 seconds. Current offset is shown in display. Press TEMP pad up arrow…
  • Temperature Adjustment (Calibration)Press and hold BAKE pad for 5 seconds. Current offset is shown in 3-digit display. CAL is shown in…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass