Model reference
Whirlpool SF357PEK
Range
2 documents20 error codes3 service modes
Available documentation
Tech Sheet
- Whirlpool Range SF357PEKQ1 Tech Sheet4 pg
Service Manual
- 30″ Freestanding Self-Cleaning Gas Range68 pg
MyPros+ Max
Diagnose your Whirlpool SF357PEK.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (20)
CodeMeaning
F0 E0Factory defaultF1 E0EEPROM Communication Error.F1 E1EEPROM Checksum Error.F1 E2A/D Error(s).F1 E4Model ID error.F1 E6Latch signal mismatch error.F2 E0Shorted keypad or key stuck.F2 E1Keytail unplugged.F3 E0Open oven temperature sensor.F3 E1Shorted oven temperature sensor.F3 E2Non-self-clean over temperature condition.F3 E3Self-clean over temperature condition.F3 E4Oven sensor openedF3 E5Oven sensor shortedF3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F5 E0Door and latch switches do not agree.F5 E1Latch motor not operating or latch switch failure.F5 E2Door latch error during clean cycle.F8 E0N/A (not applicable / reserved code).Service modes (3)
- Last Error Code RecallPress and hold the CANCEL/OFF key for 5 seconds until the last error code is displayed.
- Oven Temperature Adjustment (Temperature Knob Control)Press and hold CLOCK pad for five (5) seconds. Current offset, if any, is shown in 3-digit display…
- Oven Temperature Adjustment (Touch Pad Control)Press and hold BAKE pad for five (5) seconds. Current offset, if any, is shown in 3-digit display…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass