mypros+
Model reference

Whirlpool WFG540H0AH0

Range

11 documents15 error codes7 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10392962 - Rev A (FR)8 pg
    Covers this model
  • Tech Sheet - W10538796 - Rev A (FR)8 pg
    Covers this model
  • Tech Sheet W10538795 Rev A8 pg
    Covers this model

Service Flash

  • Whirlpool Range Service Pointer W10702913A Revised6 pg
    Covers this model
  • Service Pointer - W10702913 - Rev A (Bake Burner May Not Ignite)6 pg
    Covers this model

Tech Tip

  • Instruction Sheet4 pg
    Covers this model

Installation Guide

  • Installation Instructions40 pg
    Covers this model
  • Installation Instructions40 pg
    Covers this model
  • Instruction Sheet2 pg
    Covers this model

Quick Reference

  • Quick Reference Manual2 pg
    Covers this model
  • Oven Cleaning Quick Reference Guide2 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFG540H0AH0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (15)

CodeMeaning
F1Internal circuit board failure or A/D error(s) (displayed as F1E0, F1E1, F1E2…F1E0Internal board failure (LCC 180/190 control).F1E1Internal board failure / A/D error (LCC 180/190 control).F1E2Internal board failure / A/D error (LCC 180/190 control).F2Shorted key (keypad short circuit) (displayed as F2E0 on LCC 180/190 displays).F2E0Shorted key detected (LCC 180/190 control).F3Oven sensor open circuit (displayed as F3E0 on LCC 180/190)F3E0Oven sensor opened (LCC 180/190 control).F3E1Oven sensor shorted (LCC 180/190 control).F3E2BAKE/BROIL range over temperature condition.F3E3CLEAN range over temperature condition.F5Door and latch switch mismatch during clean mode (displayed as F5E0, F5E2 on…F5E0Door and door position switches do not agree (Clean mode) (LCC 180/190 control).F5E1Door latch not operating (Clean mode) (LCC 180/190 control).F5E2Door and door position switches do not agree (Clean mode) (LCC 180/190 control).

Service modes (7)

  • diagnosticPress CANCEL > CANCEL > START within 5 seconds.
  • Diagnostic ModePress CANCEL > CANCEL > START within 5 seconds.
  • Diagnostic Test Mode (Relay Tests)From within Diagnostic Mode, the initial display shows 'tSt' (LCC 90/95) or 'tESt' (LCC 180/190)…
  • diagnostic_test_modeWhile in diagnostic mode, press specific buttons to test each relay
  • Diagnostics ModePress CANCEL > CANCEL > START within a 5-second period.
  • Diagnostics Test Mode (Relay Checks)While in Diagnostics Mode (entered via CANCEL>CANCEL>START), press individual keys to test relays
  • Temperature AdjustmentStep 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass