Model reference
Whirlpool YGFE461LVB1
Range
4 documents13 error codes15 service modes
Available documentation
Tech Sheet
- Tech Sheet - W10435365 - Rev A8 pg
- Tech Sheet - W10435366 - Rev A (FR)8 pg
Service Flash
- Technical Service Pointer - W10412840 (Passive Door Hinge Design)6 pg
Installation Guide
- Installation Instructions16 pg
MyPros+ Max
Diagnose your Whirlpool YGFE461LVB1.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (13)
CodeMeaning
F1-E0EEPROM communication error.F1-E5Sensor out of range.F1-E7PCB thermistor open or shorted.F2-E0Keypad disconnected.F2-E1Stuck key.F2-E2Cancel key error.F3-E0Main oven sensor open or shorted.F3-E2Warming drawer sensor open or shorted.F5-E0Door and switches do not agree (Clean mode).F5-E1Door latch not operating (Clean mode).F6-E1Over temperature during cook mode.F6-E2Over temperature during clean mode.F6-E3Over temperature (warming drawer).Service modes (15)
- Auto TestEnter diagnostic mode (CANCEL > CANCEL > START), then use up arrow or '+' to scroll to AUTO TEST
- CONTROL RESETPress CANCEL > CANCEL > START to enter Service Mode
- Diagnostics Mode (Auto Test)Press CANCEL > CANCEL > START
- DISPLAYPress CANCEL > CANCEL > START to enter Service Mode
- ENG MODEPress CANCEL > CANCEL > START to enter Service Mode
- ENG MODE (Engineering Mode)Enter diagnostic mode, scroll to step 2 (ENG MODE)
- FAULTSPress CANCEL > CANCEL > START to enter Service Mode
- MRC Control Module Diagnostic ModePress CANCEL > CANCEL > START
- Temperature AdjustmentPress OVEN LIGHT for 5 seconds (current offset or 0° displayed)
- Temperature Calibration AdjustmentPress and hold OVEN LIGHT for 5 seconds. Current offset value is displayed (or 0° if none set). Use…
- TEST MODEPress CANCEL > CANCEL > START to enter Service Mode
- TEST ON - Relay ControlEnter diagnostic mode (CANCEL > CANCEL > START)
- TEST ON (Relay Checks)Press CANCEL > CANCEL > START to enter Service Mode
- USAGEPress CANCEL > CANCEL > START to enter Service Mode
- VERSIONPress CANCEL > CANCEL > START to enter Service Mode
Full entry steps, exit procedures, and test sequences are available in Max.
Related Whirlpool range models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass