mypros+
Model reference

Whirlpool W10702905

Washer

1 document16 error codes8 service modes

Available documentation

Tech Sheet

  • Laveuse Commerciale À Chargement Frontal, ModÈle CHW8990C Ou Version UltÉrieure – OpÉrations De Base16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10702905.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (16)

CodeMeaning
d13Coin 2 error; the coin 2 sensor detects that the coin slot is obstructed for 8…d16Generation 2 debit card reader error; no communication from the installed debit…d9Low voltage detection error; input voltage detected below 90 VAC for 8 seconds.F01Communication error in the Central Control Unit (CCU); the pump drive in the…F11Motor Control Module (MCM) failure, caused by repeated under-voltage or…F20No water entry detected in the washer; first pressure switch level not reached…F21Excessive drain time; drain operation exceeds 8 minutes without reaching the…F22Door lock error; the washer made multiple attempts to lock the door and failedF24Water temperature sensor value out of range (-5°C to 103°C / 23°F to 217°F).F25Tachometer error; the CCU is unable to correctly detect motor speed and the…F26Door switch error; the door switch circuit remains open for 5 seconds while the…F27Overflow condition; the overflow contact of the pressure switch has been closed…F28Communication failure between the Central Control Unit (CCU) and the Motor…F29Door unlock error; the door does not unlock after 6 attempts.F34Load detected in the washer during the washer clean cycle.F70Communication failure between the Central Control Unit (CCU) and the User…

Service modes (8)

  • Credit a Cycle["Enter diagnostic blink mode (display flashing).","Press the HOT button to credit a cycle (display…
  • Diagnostic Mode (Washer Diagnostic Mode)["Open the service door.","Press the 'Start Operating Set-up' button to enter setup mode.","Press…
  • Help Mode["Open the service door.","For manual communication
  • Manual Overview Test (Full Diagnostic Test)["Enter diagnostic blink mode (display flashing).","Press the COTTON/WHITES button."]
  • Quick Overview Test (Rapid Diagnostic Test)["Enter diagnostic blink mode (display flashing).","Press the WARM button."]
  • Quick Spin Cycle["Enter diagnostic blink mode (display flashing).","Press the PERM PRESS button."]
  • Setup Mode (Operating Setup)["Coin-operated models
  • Washer Clean Cycle (Diagnostic)["Enter diagnostic blink mode (display flashing).","Press the COLORS/DELICATES button."]

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass