mypros+
Model reference

Whirlpool W10746390

Washer

1 document36 error codes6 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10746390 - Rev D56 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10746390.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (36)

CodeMeaning
F0E2Oversuds condition detectedF0E3OverloadF0E4Spin limited by water temperatureF0E5Off balance load detected (displayed as 'OFB').F1E1Main control fault.F1E2Fault of the motor control section of the main control.F2E1User interface detecting a button is continuously activated (stuck button).F2E3UI mismatchF2E4UI software errorF2E5UI software errorF3E1Pressure system faultF3E2Inlet water temperature faultF3E4Bulk dispense faultF4E1Heater stuck onF4E2Heater not turning onF5E1Lid switch fault (lid is up)F5E2Lid lock will not lock or lid lock failure.F5E3Lid lock will not unlockF5E4Lid not opened between cyclesF6E2Communication errorF6E3Communication errorF7E0Loss of powerF7E1Loss of power during spinF7E2Motor drive module over temperatureF7E3Motor drive module over current.F7E4Motor drive module over voltage.F7E5Shifter failureF7E6Motor circuit loss of phaseF7E7Motor start failureF7E8Motor stator over temperature
View all 36 error codes
F7E9Locked rotorF8E1Long fillF8E3Overflow or flood conditionF8E6Water hazardF9E1Drain pump system problem / long drainF9E2Water ring detected / pump drive system problem

Service modes (6)

  • Key Activation & Encoder TestFrom Service Diagnostic Mode, press and release the 1st button used to activate Service Diagnostic…
  • Load Size Calibration CycleFrom Service Test Mode, select function number 052, then press START.
  • Service Diagnostic Mode1. Washer must be in standby mode (plugged in, all indicators off). 2. Select any 3 buttons (except…
  • Service Diagnostics Verification CycleFrom Service Test Mode, select function number 051 using Soil Level/Temperature buttons, then press…
  • Service Test ModeFrom Service Diagnostic Mode, press and release the 2nd button used to activate Service Diagnostic…
  • Software Version DisplayFrom Service Diagnostic Mode, press and hold the 2nd button used to activate Service Diagnostic…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass