mypros+
Model reference

Whirlpool W10918575

Washer

1 document22 error codes10 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10918575 - Rev B32 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10918575.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
d13Coin 2 error; the Coin 2 sensor is detected as blocked for 8 seconds.d16Generation 2 debit card reader error; no communication from installed debit…d5Coin 1 error; the Coin 1 sensor is detected as blocked for 8 seconds.d9Low voltage detection error; incoming voltage detected below 90 VAC for 8…F01Communication error within the Central Control Unit (CCU); the pump drive in…F04Accelerometer component failed; the X, Y, and Z limits are outside of the…F11Motor Control Unit (MCU) has a failure, possibly due to a repeating under or…F20No water detected entering washer; the first level of the pressure sensor is…F21Long drain; the drain time exceeds 8 minutes without reaching reset level in…F22Door lock error; washer makes several attempts to lock the door and fails after…F24Water temperature sensor value is out of range (23°F to 217°F / -5°C to 103°C).F25Tachometer error; the MCU is unable to properly detect motor speed and the…F26Door switch error; the door switch circuit is open for 5 seconds while the door…F27Overflow condition; the overflow contact on the pressure sensor is closed for…F28Communication failure between CCU and MCU.F29Door unlock error; the door is unable to unlock after 6 tries.F31Overheating of motor; the heat sink exceeds 212°F (100°C)F33Pump disconnected; the electrical connection between the pump and the CCU is…F34Load detected in washer during Washer Cleanout Cycle.F70Communication failure between CCU and User Interface (UI).F73Communication error within the User Interface, possibly caused by a power…F74Communication error within the User Interface, possibly caused by a power…

Service modes (10)

  • Code Display Mode["This mode can be accessed only when the washer is in error state.","Open the service door.","The…
  • Cycle Credit["Enter Flashing Mode (entire display flashing).","Press the HOT button (CC will display)."]
  • Help Mode["Enter set-up mode.","Press the WARM button until set-up code 2.XX is on display.","Press the HOT…
  • Manual Overview Test["Enter Flashing Mode (entire display flashing).","Press the COTTON/WHITES button."]
  • Quick Overview Test["Enter Flashing Mode (entire display flashing).","Press the WARM button."]
  • Quick Spin Cycle["Enter Flashing Mode (entire display flashing).","Press the PERM PRESS button."]
  • Service Access Code (alternate setup entry without removing console)["If the washer is not in failure mode, open the door.","Press the upper left button.","Press the…
  • Setup Mode["Insert access door key, turn, and lift to remove access door.","Alternatively, if a debit card…
  • Washer Cleanout Cycle["Enter Flashing Mode (entire display flashing).","Press the COLORS/DELICATES button."]
  • Washer Diagnostic Mode (Flashing Mode)["Enter Setup Mode (open service access door or insert set-up card).","Press and hold the COLD…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass