mypros+
Model reference

Whirlpool W10828193

Washer

2 documents35 error codes9 service modes

Available documentation

Tech Sheet

  • FOR SERVICE TECHNICIAN'S USE ONLY - Techsheet W1082819352 pg
    Covers this model
  • Tech Sheet - W10828193 - Rev D52 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10828193.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (35)

CodeMeaning
F0E2Oversuds condition detectedF0E3OverloadF0E4Spin limited by water temperatureF0E5Off balance load detected (also displayed as 'OFB').F1E1Main control (ACU) fault detected.F1E2Fault of the motor control section of the main control.F2E1User interface stuck buttonF2E3UI mismatchF2E4UI software errorF2E5UI software errorF3E1Pressure system faultF3E2Inlet water temperature faultF4E1Heater stuck onF4E2Heater not turning onF5E1Lid switch faultF5E2Lid lock will not lock or lid lock failureF5E3Lid lock will not unlockF5E4Lid not opened between cyclesF6E2Communication errorF6E3Communication errorF7E0Loss of powerF7E1Loss of power during spinF7E2Motor drive module over temperatureF7E3Motor drive module over current.F7E4Motor drive module over voltage.F7E5Shifter failureF7E6Motor circuit loss of phaseF7E7Motor start failureF7E8Motor stator over temperatureF7E9Locked rotor
View all 35 error codes
F8E1Long fillF8E3Overflow or flood conditionF8E6Water hazardF9E1Drain pump system problem / long drainF9E2Water ring detected, pump drive system problem

Service modes (9)

  • Fault Code DisplayFrom Service Diagnostic Mode, press and release the 3rd button used to activate Service Diagnostic…
  • Fault Code Display / Clear["Activate Service Diagnostic Mode.","Press and release the 3rd button to advance through saved…
  • Fault Code Display and ClearFrom Service Diagnostic Mode
  • Key Activation & Encoder Test["Activate Service Diagnostic Mode first.","Press and release the 1st button used to activate…
  • Load Size Calibration Cycle["Enter Service Diagnostic Mode.","Enter Service Test Mode.","Select function number 052.","Press…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Select any three buttons…
  • Service Diagnostics Verification Cycle["Enter Service Diagnostic Mode.","Enter Service Test Mode.","Select function number 051.","Press…
  • Service Test Mode["Activate Service Diagnostic Mode first.","Press and release the 2nd button used to activate…
  • Software Version Display["Activate Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass