Model reference

Whirlpool W10714946B

Washer

1 document22 error codes8 service modes

Available documentation

Service Manual

Service Diagnostic Guide - FOR SERVICE TECHNICIAN'S USE ONLY36 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10714946B.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

d13 on my Whirlpool W10714946B

M+

The Coin 2 sensor is detected as

From Tech Sheet W16529197, p.49:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (22)

CodeMeaning

d13The Coin 2 sensor is detected as blocked; coin vault may be full or sensor may…d16No communication from Gen 2 debit card reader.d5The Coin 1 sensor is detected as blocked; coin vault may be full or sensor may…d9Incoming voltage detected below 90 VAC.F01Indicates a main control fault.F03Main control detects an out of range pressure signal from the pressure sensor.F07Main control cannot determine position of shifter.F11Indicates a fault of the motor control section of the main control.F20Long fill F21Long drain F22Lid lock fault F24Inlet water temperature fault F25Main control cannot determine speed of basket, or speed changes too quickly…F26Lid switch fault F27Overflow condition F29Lid unlock fault F32No fill F70Communication failure between CCU and UI F71Communication failure between CCU and UI F73The User Interface identification does not match the expected value in the Main…F74The User Interface identification does not match the expected value in the Main…F77Off balance load detected.

Service modes (8)

Calibration Cycle (P-05)["1
Help Mode["1
Manual Overview Test (P-04)["1
Quick Overview Test (P-03)["1
Service Diagnostic Test Modes["1
Tachometer Verification (P-09)["1
Technician Service Access Code (Free Vend models only)["1
UI Diagnostics (P-07)["1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass