mypros+
Model reference

Whirlpool WFW97HEDW0

Washer

10 documents25 error codes5 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10661436 - Rev A60 pg
    Covers this model

Service Flash

  • Service Pointer - W10736964 (Unable to Access Service Diagnostics)3 pg
    Covers this model
  • Air Trap Assembly Blockage/Obstruction - Technical Service Pointer6 pg
    Covers this model
  • Technical Service Pointer3 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - Whirlpool and Maytag Direct Drive Front Load Washers Intermittent Door Lock Operation2 pg
    Covers this model
  • Technical Service Pointer - Drain Pump Assembly Relocation6 pg
    Covers this model
  • TECHNICAL SERVICE POINTER - F1E1 Error Code with Stacked Long-Vent Dryer6 pg
    Covers this model

Other

  • Whirlpool FL DD Washer Air Trap Assy Blockage Service Pointer August 2015 W108035286 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion12 pg
    Covers this model
  • Installation Instructions20 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFW97HEDW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
F1E1ACU errorF1E2Motor control errorF2E3Unsupported cycleF3E1Water level system errorF3E2Temperature system errorF3E4Mini-bulk sensor failureF4E0Heater is not detectedF5E1Door switch errorF5E2Door lock errorF5E3Door unlock errorF5E4Door not opened between cyclesF6E2Communication error ACU to UIF6E3Communication error UI to ACUF6E5Communication error between ACU and Expansion Board (EB)F7E2Motor drive circuit over temperatureF7E8Motor over temperatureF7E9Motor lock rotorF8E0Steam inlet valve errorF8E1No water detected entering washer or water level sensor trip not detectedF8E2Dispenser system errorF8E3Overflow conditionF8E4Flow meter faultF9E1Long drainrLLoad detected during the washer cleaning cycle (saved as F0E1)SudSuds detected

Service modes (5)

  • Fault/Error Code Display["Enter Service Diagnostic Mode first.","Press and release the 3rd button used to activate Service…
  • Quick Diagnostic Test["Enter Service Diagnostic Mode first.","Press and release the 2nd button used to activate Service…
  • Service Diagnostic Mode["Ensure washer is in standby mode (plugged in with all indicators off).","Wait 30 seconds after…
  • Software Version Display["Enter Service Diagnostic Mode first.","Press and hold the 2nd button used to activate Service…
  • User Interface Test["Enter Service Diagnostic Mode first.","Press and release the 1st button used to activate Service…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass